Fitting A Roller Garage Door

Hit the end of the roller in the hinge with a hammer to push it back into place.

Fitting a roller garage door.

1 box containing door curtain. 4 manual over ride equipment. After removing the old door installing the new door is done by stacking the door panels one at a time and fitting the roller tracks around the panels wheels. When the door has been delivered to yourselves the door specialist will provide assistance to position the door if assisted fit was chosen.

Replacing the bottom roller on a garage door can be extremely dangerous when done incorrectly. The supply only remote control roller garage door is designed with self installation in mind. With it s simple plug and go system that works on a standard hold to close functionality as standard and easy to follow in depth step by step fitting instructions. Before removing a heavy roller door from its bracket get a friend to help by supporting the door.

Make sure the roller is in the center of the track. Failure to adhere to these warnings may cause the door to cock jamb or fall resulting in property damage and or. This garage door is heavy and awkward to handle it is recommended that fitting this door is carried out by two people. 3 box containing electronic controls.

You ll also need a ladder and a ratchet tie down strap or rope for extra support. Once the door is supported mark the position of the door shaft on the right hand door bracket. A new garage door is a diy project any homeowner can do with a couple of strong friends. Lift the garage door so the roller and the length of track you bent are lined up again.

This is necessary not only for the lifting and manoeuvring of the door but also for the sighting and positioning of the opening mechanism. Our trained roller garage door specialist will go through any points to install the door. The roller should smoothly move up and down in the track. Please check that the door is the correct size and all component parts are present.

Typical up and over style garage door. Never loosen the bolts that secure the bottom fixture to the garage door or remove the cable from the bottom fixture.