This diy repair guide explains how to replace the chain and cable assembly on a chain drive garage door opener.
Fix a garage door opener chain.
A loose garage door opener chain makes loud slapping sounds and causes jerky door movements that smack the rollers against the track.
In this case the cable can be replaced fixing the problem.
If your garage door is closing fully and then reversing to open again then it may be due to a problem with the close limit switch.
For many generations people rely on this type of door opener not only because it is easy to use but also because it is cheap and can easily be repaired when broken.
Once you ve replaced the worn door components check the garage door opener chain.
Over time the sprocket s teeth can wear and the chain may jump or skip when the opener raises the door.
Replace the main gear drive if the garage door opener makes a grinding noise but the door doesn t move your main drive gear is probably toast.
Garage door opener won t open all the way fix.
Sometimes the cable will break if it is a combination chain and cable drive system.
So start by tightening the chain find the procedure in your owner s manual.
The chain and cable assembly connects to the trolley and drives the trolley along the rail to raise and lower the door.
The main drive gear is the plastic gear that comes in direct contact with the worm drive gear on the motor.
Chain drive garage door openers have a sprocket that is attached at the top of the motor.
In order to fix this you ll want to make small changes to the close limit setting until the door opener knows to stop once the door has reached the floor.
Chain driven garage door openers should have some slack in the chain for optimal performance.
A garage door opener chain may make a lot of noise when you pull it to open your door but it is one of the most reliable types of door openers ever invented.
Over time though this slack can increase or the gear and sprocket assembly can wear and the chain may pop off the sprockets.